Sensoray 512 DOS Manual de usuario descargar pdf (Pagina 6)

4. Hardware Installation

The 512 is installed on a PC/104 stack. Four mounting holes are provided, one in each corner,

for mechanical stability. The bus connector are the large ones as seen on the bottom of

figure 1.

This base address of the 512 must be selected using the base address selection jumper, as

seen in the lower left hand corner of figure 1. Address selection will be discussed in a following

section.

Video and digital I/O are present on five connectors. The header, J2, has all I/O signals,

including Svideo, composite video, and digital. J1, J3 are for composite video only.

BASE

ADDRESS

SELECTOR

Figure 1 Board Layout

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Sin comentarios

Sensoray 512 DOS Manual de usuario Pagina 6